Hyundai Venue (QX): Body Side Molding / Roof Side Molding. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding. Repair procedures

Replacement
Hyundai Venue. Roof Side Molding. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Take care not to scratch the body surface.
•
Install roof molding before wind shield glass & rear glass.
1.
Using a flat-tip screwdriver and remove the rood roof side molding assembly (A).

Hyundai Venue. Roof Side Molding. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Venue. Roof Side Molding. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Replacement    • Put on gloves to prevent hand injuries.

    Components Location 1. Roof rack cover 2. Roof rack assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.

    Hyundai Venue (QX) (2020-2026) Service Manual: Mode Control Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0145