| Circuit Diagram |



Troubleshooting Connector assembly status test 1. Remove the connector (A) and reinstall it. Test for changing position of each ignition coil A : Ignition coil w/ misfire code B : Ignition coil w/o misfire code • Do not move with spark plug at the same time (move the ignition coil only)
Removal 1. Disconnect the battery nagative terminal. 2. Remove the engine cover. 3.
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Removal lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.