Hyundai Venue (QX): Passenger Airbag (PAB) Module / Side Airbag (SAB) Module. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Restraint / Passenger Airbag (PAB) Module / Side Airbag (SAB) Module. Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly")
3.
Remove the front seat back cover.
(Refer to Body - "Front Seat Back Cover")
4.
Remove the side airbag from the seat back after loosening the mounting nut.

Hyundai Venue. Side Airbag (SAB) Module. Repair procedures
Installation
Hyundai Venue. Side Airbag (SAB) Module. Repair procedures   
•
Be sure to install the harness wires not to be pinched or interfered with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Disconnect the battery negative cable and wait for at least three minutes.
4.
Install the side airbag.
Tightening torque :
6.0 - 7.8 N.m (0.6 - 0.8 kgf.m, 4.4 - 5.8 Ib-ft)
5.
Install the front seat back cover.
(Refer to Body - "Front Seat Back Cover")
Hyundai Venue. Side Airbag (SAB) Module. Repair procedures   
•
Make sure that the seat back cover is installed properly. Improper installation may prevent the proper deployment.
6.
Install the front seat assembly.
(Refer to Body - "Front Seat Assembly")
7.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
8.
Reconnect the battery negative cable.
9.
After installing the side airbag (SAB), confirm proper system operation :
•
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

    Components 1. Side Airbag (SAB)

    Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Description and operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.

    Hyundai Venue (QX) (2020-2026) Service Manual: Warning Indicator. Components and components location

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front door trim") 3. Disconnect the power door mirror connector from the harness 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0214