| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes
before beginning work.
|
| 2. |
Remove the door scuff trim.
(Refer to Body - "Interior Trim")
|
| 3. |
Remove the center pillar trim.
(Refer to Body - "Interior Trim")
|
| 4. |
Loosen the side impact sensor mounting bolt (A) and remove the side
impact sensor.
|
| Installation |
|
| 1. |
Install the new side impact sensor with the bolt (A) then connect the
side impact sensor connector.
|
| 2. |
Install the center pillar trim.
(Refer to Body - "Interior Tirm")
|
| 3. |
Install the door scuff trim.
(Refer to Body - "Interior Tirm")
|
| 4. |
Reconnect the battery negative cable.
|
| 5. |
After installing the Side Impact Sensor, confirm proper system operation
:
|
Components 1. Side Impact Sensor (SIS)
Refrigerant System Service Basics (R-134a) Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system.
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.