| Troubleshooting |
| Problem Symptoms Table |
|
Symptom |
Suspected Area |
|
No blower operation |
1. Blower fuse |
|
2. Blower relay |
|
|
3. Blower motor |
|
|
4. Power mosfet |
|
|
5. Blower speed control switch |
|
|
6. Wire harness |
|
|
No air temperature control |
1. Engine coolant capacity |
|
2. Heater control assembly |
|
|
No compressor operation |
1. Refrigerant capacity |
|
2. A/C fuse |
|
|
3. Compressor |
|
|
4. A/C pressure transducer |
|
|
5. A/C switch |
|
|
6. Evaporator temperature sensor |
|
|
7. Wire harness |
|
|
Vented air not cold |
1. Refrigerant capacity |
|
2. Refrigerant pressure |
|
|
3. Drive belt |
|
|
4. Compressor |
|
|
5. A/C pressure transducer |
|
|
6. Evaporator temperature sensor |
|
|
7. A/C switch |
|
|
8. Heater control assembly |
|
|
9. Wire harness |
|
|
Insufficient cooling |
1. Refrigerant capacity |
|
2. Drive belt |
|
|
3. Compressor |
|
|
4. Condenser |
|
|
5. Expansion valve |
|
|
6. Evaporator |
|
|
7. Refrigerant lines |
|
|
8. A/C pressure transducer |
|
|
9. Heater control assembly |
|
|
No engine idle-up when A/C switch ON |
1. Engine ECM |
|
2. Wire harness |
|
|
No air inlet control |
1. Heater control assembly |
|
No mode control |
1. Heater control assembly |
|
2. Mode actuator |
|
|
No cooling fan operation |
1. Cooling fan fuse |
|
2. Fan motor |
|
|
3. Engine ECM |
|
|
4. Wire harness |
Specification Air Conditioner item Specification Compressor Type DVE12N Oil type & Capacity PAG 30 120 ± 10cc (4.
Special Service Tools Tool (Number and name) Illustration Use 09977-3R000 Disc & hub assembly bolt remover Removal and installation of disc & hub assembly.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shroud panel.
Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.