| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crashpad lower panel.
(Refer to BODY - "Crashpad Lower Panel")
|
| 3. |
Disconnect the SSB connector (A).
|
| 4. |
Remove the SSB button (A) after loosening mounting screws.
|
| Installation |
| 1. |
Install the start/stop button.
|
| 2. |
Install the crash pad center panel.
|
| 3. |
Connect the negative (-) battery terminal.
|
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Inspection 1. Loosen the cruise control switch connector. 2. Check for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel