Hyundai Venue (QX): Starting System / Starter Relay. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Electrical System / Starting System / Starter Relay. Repair procedures

Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).

Hyundai Venue. Starter Relay. Repair procedures
4.
Using an ohmmeter, check that there is continuity between each terminal.
Terminal
Value
Measure
30 - 87
 1MΩ or Higher
 If there is continuity, replace the relay.
85 - 86
 continuity
 If there is no continuity, replace the relay.

Hyundai Venue. Starter Relay. Repair procedures
5.
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
Terminal
Continuity
30 - 87
 Below 1Ω
85 - 86
 Apply 12V

Hyundai Venue. Starter Relay. Repair procedures
6.
If there is no continuity, replace the starter relay.
7.
Install the starter relay.
8.
Install the fuse box cover.

    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the air cleaner assembly.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Hyundai Venue (QX) (2020-2026) Service Manual: Rear Corner Radar Unit. Repair procedures

    Removal    lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0144