Hyundai Venue (QX): TailGate / Tail Gate Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / TailGate / Tail Gate Assembly. Repair procedures

Replacement
1.
Remove the TailGate trim.
(Refer to tailgate - "Tailgate Trim")
2.
Using a flat-tip screwdriver, lift up slightly the socketclips (A) of both ends on the lifter (B), and thenremove the lifter from the bracket.

Hyundai Venue. Tail Gate Assembly. Repair procedures
3.
Separate the tailgate main wiring (A) from theTailGate.
4.
Separate the nozzle (B).
5.
Loosen the mounting bolts and remove the tailgateassembly (C).
Tightening torque :
21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)

Hyundai Venue. Tail Gate Assembly. Repair procedures
6.
To install, reverse removal procedure.
Hyundai Venue. Tail Gate Assembly. Repair procedures   
•
Make sure the tailgate locks / unlocks and opens /closes properly.
•
Adjust the tailgate alignment.
•
Make sure the connectors are connected in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Tailgate assembly

    Component Location 1. Tailgate trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Variant Coding    When you need variant coding: – Replace Front View Camera with a new one ※ EOL Variant Coding and calibration required for new replacement Front View Camera Variant Coding

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0178