Hyundai Venue (QX): Manual Transaxle System / Troubleshooting

Troubleshooting
Symptom
Suspected Area
Remedy 
Abnormal noise
Oil level (Low)
To adding oil after inspect the parts (Oil seal, Drain plug, filler plug).
Oil (Wrong)
Replace the oil.
Synchronizer ring (Worn or damaged)
Replace the synchronizer ring.
Gear (Worn or damaged)
Replace the gear.
Bearing (Worn or damaged)
Replace the bearing.
Oil leak
Oil level (High)
Inspect the oil level.
Gasket (Damaged)
Replace the gasket.
Oil seal (Worn or damaged)
Replace the oil seal.
Hard shifting or impossible to shift
Oil (Wrong)
Replace the oil.
Clutch (Dragging)
Inspect the clutch parts (Release fork & bearing, Clutch disc)
Shift fork (Worn)
Replace the shift fork.
Synchronizer ring (Worn or damaged)
Replace the synchronizer ring.
Gear (Worn or damaged)
Replace the gear.
Hub sleeve (Worn or damaged)
Replace the hub sleeve.
Jumps out of gear or shift lever moves excessively
Shift fork (Worn)
Replace the shift fork.
Hub sleeve (Worn or damaged)
Replace the hub sleeve.
Gear (Worn or damaged)
Replace the gear.
Bearing (Worn or damaged)
Replace the bearing.

    Special Service Tools Tool (Number and name) Illustration Use 09200-3N000 Engine support fixture (Beam) Removal and installation of the transaxle.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Refrigerant Line. Repair procedures

    Replacement 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal.

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0179