Troubleshooting Symptom Suspected Area Remedy Abnormal noise Oil level (Low) To adding oil after inspect the parts (Oil seal, Drain plug, filler plug).
Components 1. Control shaft complete 2. Manual transaxle case 3. Clutch housing 4. Back-up lamp switch 5. Manual transaxle support bracket 6.
Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.