Hyundai Venue (QX): Rear Bumper / Rear Bumper beam Assembly. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly. Repair procedures

Replacement
Hyundai Venue. Rear Bumper beam Assembly. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
2.
Disconnect the rear bumper beam mounting wiring harness (A).

Hyundai Venue. Rear Bumper beam Assembly. Repair procedures
3.
Loosen the mounting clips, remove the rear bumper beam assembly (A).

Hyundai Venue. Rear Bumper beam Assembly. Repair procedures
4.
To install, reverse removal procedure.
Hyundai Venue. Rear Bumper beam Assembly. Repair procedures   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Rear bumper beam assembly

    Other information:

    Hyundai Venue (QX) (2020-2025) Service Manual: Repair procedures

    Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3.

    Hyundai Venue (QX) (2020-2025) Service Manual: Schematic diagrams

    System Block Diagram Component Parts And Function Outline Component part Function Vehicle-speed sensor, ESP/ABS Control Module Converts vehicle speed to pulse. ECM Receives signals from sensor and control switches.

    Categories

     
    Copyright © 2025 www.hvenueqx.com - 0.0093