Hyundai Venue (QX): Rear Door / Rear Door Inside Handle. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Inside Handle. Repair procedures

Removal

1.	Remove the front door trim. (Refer to Front Door - "Front Door Trim")

Cut the heat welds with a knife and remove the front door inside handle (A).

Hyundai Venue. Rear Door Inside Handle. Repair procedures

•	Cut the heat welds with a knife, paying attention to damage.

Installation

1.	Refit the rear door interior handle.

Refit the screws on the heat welds.

•	Since there is no groove to mount the screw, place the screw driver in a straight line and install it.

❮Rear Door Module. Repair procedures

Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.

Rear Door Outside Handle. Components and components location❯

Component Location 1. Rear door outside handle

Other information:

Hyundai Venue (QX) (2020-2026) Service Manual: Ambient Temperature Sensor. Description and operation

Description The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.

Hyundai Venue (QX): Rear Door / Rear Door Inside Handle. Repair procedures

Other information:

Hyundai Venue (QX) (2020-2026) Service Manual: Ambient Temperature Sensor. Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (DATC). Components and components location

Categories