Hyundai Venue: Rear Door / Rear Door Trim. Components and components location

Hyundai Venue (QX) (2020-2025) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Trim. Components and components location

Component Location

Hyundai Venue. Rear Door Trim. Components and components location

1. Rear door trim

Repair procedures

Adjustment Glass Adjustment • Check the glass run channel for damage or deterioration, and replace it if necessary...

Rear Door Trim. Repair procedures

Replacement • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components...

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: Start/Stop Button. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crashpad lower panel. (Refer to BODY - "Crashpad Lower Panel") 3. Disconnect the SSB connector (A)...

Hyundai Venue (QX) (2020-2025) Service Manual: Tail Gate Trim. Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components...

Categories

Air bag collision sensors

WARNING

To reduce the risk of an air bag deploying unexpectedly and causing serious injury or death:

Do not hit or allow any objects to impact the locations where air bags or sensors are installed. Do not perform maintenance on or around the air bag sensors. If the location or angle of the sensors is altered, the air bags may deploy when they should not or may not deploy when they should. Do not install bumper guards or replace the bumper with a nongenuine HYUNDAI parts. This may adversely affect the collision and air bag deployment performance. Place the ignition switch in the LOCK/OFF or ACC position when the vehicle is being towed to prevent inadvertent air bag deployment. Have all air bag repairs conducted by an authorized HYUNDAI dealer.

Hyundai Venue. Air bag collision sensors