Hyundai Venue: Automatic Transaxle System / Special service tools

Hyundai Venue (QX) (2020-2024) Service Manual / Automatic Transaxle System / Special service tools

Special Service Tools
Tools
(Number and name)
Illustration
Use
09200-3N000
Engine support fixture (Beam)

Hyundai Venue. Special service tools

Removal and installation of the transaxle.
Use this beam (SST No. : 09200-3N000) with the supporter (SST No. : 09200-2S000).
※Permit operating with 09200-38001.
09200-2S000
Engine support fixture (Supporter)

Hyundai Venue. Special service tools

Removal and installation of the transaxle.
Use this supporter (SST No. : 09200-2S000) with the beam (SST No. : 09200-38001/3N000)).
09452-26100
Oil seal installer

Hyundai Venue. Special service tools

Installation of the differential oil seal in the transaxle case and housing side(2WD).
[Using with bar (SST No.09231-H1100)]
09231-H1100
Bar

Hyundai Venue. Special service tools

Installation of the differential oil seal in the transaxle case and housing side.
[Using with oil seal installer (SST No.:09452-26100)]
09480-A3800
Inhibitor switch neutral fixed pin

Hyundai Venue. Special service tools

When installing the manual control lever on the inhibitor switch, used to align the neutral position.

    Specifications

    Specifications Item Specifications Transaxle type A6GF1 - 2 Engine type Gasoline 1...

    Troubleshooting

    Troubleshooting ▶ Fault Diagnosis Features a fail-safe mechanism that provides "limp-home" 4th gear hold to enable the vehicle to be driven to the owner's home or dealer shop...

    Other information:

    Hyundai Venue (QX) (2020-2024) Service Manual: Troubleshooting


    Standard Flow of Diagnostic Troubleshooting Notes With Regard To Diagnosis The phenomena listed in the following table are not abnormal. Condition Explanation System check sound When starting the engine, a thudding sound can sometimes be heard coming from inside the engine compartment...

    Hyundai Venue (QX) (2020-2024) Service Manual: PDM (Power Distribution Module). Repair procedures


    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the MDPS. (Refer to Steering System - "Motor Driven Power Steering") 3. Remove the PDM relay box (A) after mouting nuts and disconnecting the connector...

    Categories

    Seat Belt Warning Light

    Seat belt warning light (for driver’s seat)

    Hyundai Venue. Seat Belt Warning Light

    As a reminder to the driver, the seat belt warning light will illuminate for approximately 6 seconds each time you place the ignition switch to the ON position regardless of belt fastening. However, if the seat belt is unfasted, a warning chime will sound for approximately 6 seconds.

    read more


     
    Copyright © 2024 www.hvenueqx.com