Hyundai Venue: Convenient Features / Wipers and Washers

Front windshield wiper/washer

Rear windshield wiper/washer
A. Wiper speed control
- MIST – Single wipe
- OFF – Off
- INT – Intermittent wipe
- LO– Low wiper speed
- HI – High wiper speed
B. Intermittent control wipe time adjustment
C. Wash with brief wipes (pull lever towards you)
D. Rear wiper/washer control
- HI – High wiper speed
- LO – Low wiper speed
- OFF – Off
E. Wash with brief wipes (rear) (push lever away from you)
Push the switch to turn the light on or off.
: The lamp will turn on if
this button is pressed.
: The lamp will turn off if
this button is pressed...
Operates as follows when the ignition switch is in the ON position.
MIST: For a single wiping cycle, push the lever upward and release. The wipers
will operate continuously if the lever is held in this position...
Other information:
TCM Connector
Connector [A]
Pin
Description
2
35R clutch control solenoid valve (35R/C_VFS)
4
26 brake control solenoid valve (26/B_VFS)
5
Underdrive brake control solenoid valve (UD/B_VFS)
8
Inhibitor switch signal S2 (R)
19
Line pressure control solenoid valve (LINE_VFS)
21
Input speed sensor power
22
Output speed sensor power
32
Torque converter control solenoid valve (T/CON_VFS)
33
VB (Battery voltage)
34
Solenoid supply power 2
37
Output speed sensor signal
38
Inhibitor switch signal S4 (D)
39
Inhibitor switch signal S1 (P)
40
Manual mode up shift
42
Manual mode select switch
43
Oil temperature sensor (+)
45
VB (Battery voltage)
46
ON/OFF solenoid valve A(SS-A)
47
Overdrive clutch control solenoid valve (OD/C_VFS)
48
VB (Battery voltage)
49
Solenoid supply power 1
52
Input speed sensor signal
54
Inhibitor switch signal S3 (N)
57
Manual mode down shift
58
Oil temperature sensor (-)
TCM Terminal input/ output signal
Connector [A]
Pin
Description
Condition
Input/output value
Type
Level
2
35R clutch control solenoid valve
(35R/C_VFS)
-
Output
0V/Battery voltage level
9V < Battery voltage level < 16V
4
26 brake control solenoid valve
(26/B_VFS)
-
Output
0V/Battery voltage level
9V < Battery voltage level < 16V
5
Underdrive brake control solenoid valve
(UD/B_VFS)
-
Output
0V/Battery voltage level
9V < Battery voltage level < 16V
8
Inhibitor switch signal S2 (R)
High
Input
0V/Battery voltage level
Low
9V < Battery voltage level < 16V
19
Line pressure control solenoid valve
(LINE_VFS)
-
Output
0V/Battery voltage level
9V < Battery voltage level < 16V
21
Input speed sensor power
ON
Power
0V/9V
OFF
22
Output speed sensor power
ON
Power
0V/9V
OFF
32
Torque converter control solenoid valve
(T/CON_VFS)
-
Output
0V/Battery voltage level
9V < Battery voltage level < 16V
34
Solenoid power 2
Power
0V/Battery voltage level
9V < Battery voltage level < 16V
37
Output speed sensor signal
High
Input
0...
..
Categories
Seat belt warning light (for driver’s seat)

As a reminder to the driver, the seat belt warning light will illuminate for
approximately 6 seconds each time you place the ignition switch to the ON position
regardless of belt fastening. However, if the seat belt is unfasted, a warning chime
will sound for approximately 6 seconds.
read more