Hyundai Venue (QX): Fuel Delivery System / Accelerator Pedal. Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation nuts (A), and then remove the accelerator pedal
module.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Open the fuel filler door and unfasten the filler-neck assembly mounting botl (A).
Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2.
Other information:
Hyundai Venue (QX) (2020-2025) Service Manual: Compressor. Description and operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Hyundai Venue (QX) (2020-2025) Service Manual: Blower Resistor (Manual). Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Child-Protector Rear Door Locks
- Maintenance
- Normal Maintenance Schedule
- New on site
- Most important about car
