Hyundai Venue (QX): Fuel Delivery System / Filler-Neck Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly. Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Open the fuel filler door and unfasten the filler-neck assembly mounting botl (A).
Filler-neck assembly bracket installation bolt :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Venue. Filler-Neck Assembly. Repair procedures
3.
Lift the vehicle.
4.
Remove the rear-LH wheel, tire, and the inner wheel house.
5.
Disconnect the fuel filler hose (A).
6.
Disconnect the ventilation hose (B) and leveling hose quick-connector (C).

Hyundai Venue. Filler-Neck Assembly. Repair procedures
7.
Remove the filler-neck assembly from the vehicle after removing the bracket mounting bolt (A).
Filler-neck assembly installation bolt :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Venue. Filler-Neck Assembly. Repair procedures
Installation
1.
Install in the reverse order of removal.

    Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Release the residual pressure in fuel line.

    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A).

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Refrigerant System Service Basics (R-134a) Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system.

    Hyundai Venue (QX) (2020-2026) Service Manual: Rear Corner Radar Unit. Repair procedures

    Removal    lf replacement of the rear corner radar unit bracket or extension wire is required, replace the defective part only with a new one. 1.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0107