Hyundai Venue: Manual Transaxle Control System / Control Shaft Complete. Components and components location

1. Control shaft complete
|
|
Removal
1.
Turn OFF ignition switch and disconnect the negative (-) battery cable.
2.
Remove the air cleaner and air duct...
Removal
1.
Set shift lever to N position.
2.
Turn OFF ignition switch and disconnect the negative (-) battery cable...
Other information:
I : Inspect and if necessary, adjust, correct, clean or replace.
R : Replace or change.
*1 : The drive belt should be replaced when cracks occur or tension is reduced
excessively.
*2 : If TOP TIER Detergent Gasoline is not available, one bottle of additive
is recommended...
Cooling / Ventilation
1. Select the Face Level mode.
2. Set the air intake control to fresh mode.
3. Set the temperature control to the desired position.
4. Set the fan speed control to the desired speed.
Heating
1. Select the Floor Level mode...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air bags
or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If the location
or angle of the sensors is altered, the air bags may deploy when they should
not or may not deploy when they should.
Do not install bumper guards or replace the bumper with a nongenuine
HYUNDAI parts. This may adversely affect the collision and air bag deployment
performance.
Place the ignition switch in the LOCK/OFF or ACC position when the vehicle
is being towed to prevent inadvertent air bag deployment.
Have all air bag repairs conducted by an authorized HYUNDAI dealer.

read more