Hyundai Venue: Engine Control System / Crankshaft Position Sensor (CKPS)
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect ECTS connector.
3.
Remove the ECTS...
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important sensors of the engine control system...
Other information:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper Cover")
3.
Remove the rear fog lamp assembly (A) after loosening the mounting screws...
Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation by confirmation logic as follows;
1.
Entering
(1)
Set the Floor mode and maximum heating position.
(2)
Turn off the blower switch...
Categories
WARNING
To reduce the risk of an air bag deploying unexpectedly and causing serious
injury or death:
Do not hit or allow any objects to impact the locations where air bags
or sensors are installed.
Do not perform maintenance on or around the air bag sensors. If the location
or angle of the sensors is altered, the air bags may deploy when they should
not or may not deploy when they should.
Do not install bumper guards or replace the bumper with a nongenuine
HYUNDAI parts. This may adversely affect the collision and air bag deployment
performance.
Place the ignition switch in the LOCK/OFF or ACC position when the vehicle
is being towed to prevent inadvertent air bag deployment.
Have all air bag repairs conducted by an authorized HYUNDAI dealer.

read more