Hyundai Venue: Driveshaft Assembly / Dynamic Damper. Components and components location
![Hyundai Venue. Dynamic Damper. Components and components location](images/dynamic_damper_components_and_components_location-646/287/hyundai_venue__dynamic_damper_components_and_components_location_1529.gif)
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
|
5. Dynamic damper
6. Shaft
7. TJ boot band
8. TJ boot
|
9. Spider assembly
10. Snap ring
11. TJ housing
12. Clip
|
Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2...
Removal
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - "Front Driveshaft")
2...
Other information:
Replacement
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module
and detects the rotation angle of the accelerator pedal. The APS is one of the
most important sensors in engine control system, so it consists of the two sensors
which adapt individual sensor power and ground line...
Categories
![Hyundai Venue. Remote Key](images/books/1/hyundai_venue_remote_key_173.png)
Your HYUNDAI uses a remote key, which you can use to lock or unlock the driver
and passenger doors or the rear liftgate.
(1) Door Lock
(2) Door Unlock
(3) Panic
Locking Your Vehicle
To lock your vehicle:
1. Make sure all doors, the engine hood and the liftgate are closed.
read more