Hyundai Venue: Engine And Transmission Assembly / Engine Mounting. Components and components location
Hyundai Venue (QX) (2020-2022) Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Mounting. Components and components location
| Components |
| 1. Engine mounting bracket 2. Engine mounting support bracket |
3. Roll road bracket 4. Transaxle mounting bracket |
Engine Room Under Cover. Repair procedures
Removal and Installation
1.
Remove the engine room under cover (A).
Tightening torque :
3...
Engine Mounting. Repair procedures
Removal and Installation
[Roll road Mounting]
1.
Remove the Roll rod mounting (A).
Tightening torque
Bolt (B) :
107...
Other information:
Hyundai Venue (QX) (2020-2022) Service Manual: Heater & A/C Control Unit (DATC). Components and components location
..
Hyundai Venue (QX) (2020-2022) Service Manual: Rear Coil Spring. Repair procedures
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from the rear hub. Tightening torque : 107...
Categories
- Manuals Home
- 1st Generation Venue Owners Manual
- 1st Generation Venue Service Manual
- To set Cruise Control speed
- System Setting and Activation
- Instrument Cluster
- New on site
- Most important about car
Fuel gauge
This gauge indicates the approximate amount of fuel remaining in the fuel tank.
Information
The fuel tank capacity is given in chapter 2. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On inclines or curves, the fuel gauge pointer may fluctuate or the low fuel warning light may come on earlier than usual due to the movement of fuel in the tank.
Copyright © 2022 www.hvenueqx.com