Hyundai Venue (QX): SRSCM / Front Impact Sensor (FIS). Description and operation
| Description |
| • |
The front impact sensor (FIS) is installed on the upper of the side
panel in Front End Module (FEM). They are remote sensors that detect
acceleration due to a collision at their mounting locations.
|
| • |
The primary purpose of the Front Impact Sensor (FIS) is to provide an
indication of a collition. The Front Impact Sensor (FIS) sends acceleration
data to the SRSCM.
|
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
Components 1. Front right Impact Sensor (FIS) 2. Front Left Impact Sensor (FIS)
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Compressor oil. Repair procedures
Oil Specification 1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor (PAG) oil varies according to compressor model.
Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Remote start
- Child-Protector Rear Door Locks
- Normal Maintenance Schedule
- New on site
- Most important about car
