Hyundai Venue: SRSCM / Front Impact Sensor (FIS). Repair procedures
| • |
Removal of the airbag must be performed according to the precautions/
procedures described previously.
|
| • |
Before disconnecting the front impact sensor connector, disconnect
the front airbag connector(s).
|
| • |
Do not turn the ignition switch ON and do not connect the battery
cable while replacing the front impact sensor.
|
|
| 1. |
Disconnect the battery negative cable, and wait for at least three minutes
before beginning work.
|
| 2. |
Disconnect the front impact sensor connector (A) and then remove the
front impect sensor (B).
|
| • |
Do not turn the ignition switch ON and do not contact the battery
cable while replacing the front impact sensor.
|
|
| 1. |
Install the new front impact sensor.
|
| 2. |
Connect the front impact sensor connector.
|
| 3. |
Install the front impact sensor mounting bolt.
|
Tightening torque :
6.8 - 7.5 N.m (0.7 - 0.76 kgf.m, 5.0 - 5.5 Ib-ft)
|
|
| 4. |
Reconnect the battery negative cable.
|
| 5. |
After installing the Front Impact Sensor, confirm proper system operation
:
| • |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
Description
Side Impact Sensor (SIS) system consists of two SIS which are installed at each
center pillar nearby (LH and RH).
Side Impact Sensor is also called A-SIS because it detects acceleration...
Other information:
Inspection
•
Refer to the DTC manual for the check procedure.
Removal
•
When the solenoid valve Diagnostic Trouble Codes (DTC) is on,
perform the following procedure to replace it...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-)
terminal.
2.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3...
Categories
1. Door lock/unlock button
2. Outside rearview mirror control switch
3. Central door lock switch
4. Power window switches
5. Power window lock switch
read more
Side Impact Sensor (SIS). Description and operation