| Component Location |

| 1. Hood latch assembly |
Replacement 1. Pull out the hood latch release handle. 2. Separate the hood latch release handle cable (A).
Replacement 1. Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover") 2.
Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.
Inspection 1. Loosen the cruise control switch connector. 2. Check for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel