Hyundai Venue (QX): Hood / Hood Latch. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Hood / Hood Latch. Repair procedures

Replacement
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Separate the hood latch connector (A) and loosen the mounting clips.

Hyundai Venue. Hood Latch. Repair procedures
3.
Separate the hood latch cable (A).

Hyundai Venue. Hood Latch. Repair procedures
4.
Loosen the mounting nuts and remove the hood latch assembly (A).

Hyundai Venue. Hood Latch. Repair procedures
5.
To install, reverse removal procedure.
Hyundai Venue. Hood Latch. Repair procedures   
•
Make sure the hood latch release cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the latch alignment.
•
Replace any damaged clips (or retainers or fasteners)

    Component Location 1. Hood latch assembly

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Repair procedures

    Removal    Precautions for using the plastic pulley • Be careful not to place the pulley to downwards of the floor or table.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0185