Hyundai Venue: Immobilizer System / Immobilizer Control Unit. Repair procedures

Hyundai Venue (QX) (2020-2025) Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit. Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the glove box. (Refer to Body - "Glove Box Housing")

3.	Remove the smart key unit (A) after loosening the nuts.

4.	Remove the smart key unit the connectors (A).

•	For the european specification, when removing the IBU connector, the IBU will be damaged by safety bracket (A). So, replace IBU with a new one.

Hyundai Venue. Immobilizer Control Unit. Repair procedures

Installation

1.	Install the body control module.

2.	Install the glove box.

Repair procedures

Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS...

Antenna Coil. Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel...

Other information:

Hyundai Venue (QX) (2020-2025) Service Manual: Hood Latch Release Handle. Repair procedures

Replacement 1. Pull out the hood latch release handle. 2. Separate the hood latch release handle cable (A). 3. Loosen the mounting screws and remove the hood latch release handle (A)...

Hyundai Venue (QX) (2020-2025) Service Manual: Clutch Master Cylinder. Repair procedures

Removal 1. Separate the push rod (A) from the clutch pedal. 2. Turn ignition switch OFF and disconnect the negative (-) battery cable. 3. Remove the air cleaner and air duct...