| Removal |
| 1. |
Disconnect (-) battery terminal.
|
| 2. |
Using a fastener remover (C), remove the mirror (A) as illustration
below.
|
| 3. |
Disconnect the mirror connector (A).
|
| 4. |
Remove the mirror actuator mounting screw.
|
| 5. |
Disconnect the connector (A) and then remove the mirror actuator.
|
| Installation |
| 1. |
Connect the actuator connector and then install the mirror actuator.
|
| 2. |
Install the mirror.
|
| 3. |
Connect (-) battery terminal then check if mirror works normally.
|
Power Door Mirror Switch. Repair procedures
This warning light informs the driver the following situations.
-- Forward Collision-Avoidance Assist system malfunction (if equipped)
-- Forward Collision-Avoidance Assist radar blocked (if equipped)
-- Blind-Spot Collision Warning system malfunction (if equipped)
-- Blind-Spot Collision Warning radar blocked (if equipped)
-- Lamp malfunction (if equipped)
-- High Beam Assist malfunction (if equipped)
-- Tire Pressure Monitoring System (TPMS) malfunction (if equipped)