| Circuit Diagram |



Specification Items Specification APS 1 APS 2 C.T 0.
Inspection 1. Connect the diagnostic tool on the Diagnosis Link Connector (DLC). 2. Start engine and check output voltages of APS 1 and 2 at C.
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.