| Removal |
| 1. |
Remove the rear roof trim.
(Refer to Body - "Roof Trim Assembly")
|
| 2. |
Disconnect the roof antenna cable and connector (A) and then remove
the antenna mounting nut (B).
|
| 3. |
Remove the roof antenna (A).
|
| Installation |
| 1. |
Connect the roof antenna connectors.
|
| 2. |
Install the rear roof trim.
|
Components
Components 1. Remote control switch (LH) 2. Trip switch (RH)
Inspection The following section describes how to diagnose faults using a diagnostic instrument. 1. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, and turn on the GDS.
Component Location 1. Blower unit assembly Component Location 1. Intake seal 2. Intake upper case 3. Intake actuator 4. Intake door 5. Intake lower case 6. Blower pad 7.