Hyundai Venue (QX): Cylinder Head Assembly / Components and components location
| Components |
| 1. Cylinder head cover 2. Cylinder head cover gasket 3. Cylinder head assembly 4. Cylinder head gasket |
5. Camshaft front bearing cap 6. Camshaft bearing cap 7. Camshaft position sensor 8. OCV (oil control valve) 9. O-ring |
| 1. Exhaust camshaft 2. Intake camshaft 3. Exhaust camshaft sproket 4. CVVT assembly 5. Mechanical Lash Adjuster(MLA) 6. Retainer lock 7. Retainer |
8. Valve stem seal 9. Valve spring 10. Valve spring seat 11. Intake valve 12. Exhaust valve 13. Oil Control Valve(OCV) |
Adjustment Valve Clearance Inspection and Adjustment • Inspect and adjust the valve clearance when the engine is cold (Engine coolant temperature : 20°C) and cylinder head is installed on the cylinder block.
Components 1. Cylinder head cover 2. Cylinder head cover gasket
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Mode Control Actuator. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.
Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation
Description Rear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Tire Pressure Monitoring System (TPMS) (Type A)
- Electronic Stability Control (ESC)
- Rear Seat Assembly. Repair procedures
- New on site
- Most important about car
