| Components Location |

| 1. ECM (Engine Control Module) 2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle Position Sensor (TPS) [integrated into ETC Module] 6. Crankshaft Position Sensor (CKPS) 7. Camshaft Position Sensor (CMPS) [Bank 1 / Intake] 8. Camshaft Position Sensor (CMPS) [Bank 1 / Exhaust] 9. Knock Sensor (KS) 10. Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 1] 11. Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 2] 12. Accelerator Position Sessor (APS) |
13. A/C Pressure Transducer (APT) 14. ETC Motor [integrated into ETC Module] 15. Injector 16. Purge Control Solenoid Valve (PCSV) 17. CVVT Oil Control Valve (OCV) [Bank 1 / Intake] 18. CVVT Oil Control Valve (OCV) [Bank 1 / Exhaust] 19. Variable Intake Solenoid (VIS) Valve 20. Ignition Coil 21. Main Relay 22. Fuel Pump Relay 23. Data Link Connector (DLC) [16 pin] 24. Multi-Purpose Connector [6 pin] |
|
1. ECM (Engine Control Module) |
2. Manifold Absolute Pressure Sensor (MAPS) 3. Intake Air Temperature Sensor (IATS) |
|
|
|
|
4. Engine Coolant Temperature Sensor (ECTS) |
5. Throttle Position Sensor (TPS) [Integrated into ETC Module] 14. ETC Motor [integrated into ETC Module] |
|
|
|
|
6. Crankshaft Position Sensor (CKPS) |
7. Camshaft Position Sensor (CMPS) [Bank 1 / Intake] |
|
|
|
|
8. Camshaft Position Sensor (CMPS) [Bank 1 / Exhaust] |
9. Knock Sensor (KS) |
|
|
|
|
10. Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 1] |
11. Heated Oxygen Sensor (HO2S) [Bank 1 / Sensor 2] |
|
|
|
|
12. Accelerator Position Sessor (APS) |
13. A/C Pressure Transducer (APT) |
|
|
|
|
15. Injector 20. Ignition Coil |
16. Purge Control Solenoid Valve (PCSV) |
|
|
|
|
17. CVVT Oil Control Valve (OCV) [Bank 1 / Intake] |
18. CVVT Oil Control Valve (OCV) [Bank 1 / Exhaust] |
|
|
|
|
19. Variable Intake Solenoid (VIS) Valve |
21. Main Relay 22. Fuel Pump Relay |
|
|
|
|
23. Data Link Connector (DLC) [16 pin] |
24. Multi-Purpose Check Connector [6 pin] |
|
|
|
Description If the Gasoline Engine Control system components (sensors, ECM, injector, etc.) fail, interruption to the fuel supply or failure to supply the proper amount of fuel for various engine operating conditions will result.
Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received which is transferred to th
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.