| Components |

| 1. Control shaft complete 2. Manual transaxle case 3. Clutch housing |
4. Back-up lamp switch 5. Manual transaxle support bracket 6. Control cable bracket |
Removal 1. Turn OFF ignition switch and disconnect the negative (-) battery cable. 2. Remove the air cleaner and air duct.
Removal Precautions for using the plastic pulley • Be careful not to place the pulley to downwards of the floor or table.
Removal 1. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 2. Loosen the mounting screws and remove the rear view camera. Installation 1.