Hyundai Venue (QX): Engine Control System / CVVT Oil Control Valve (OCV). Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect OCV connector.
|
| 3. |
Measure resistance between OCV terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
terminal.
|
| 2. |
Disconnect the CVVT oil control valve connector (A).
|
| 3. |
Remove the mounting bolt (B), and then remove the valve from the engine.
[Bank 1 / Intake]
[Bank 1 / Exhaust]
|
| Installation |
|
|
| 1. |
Install in the reverse order of removal.
|
Circuit Diagram [M/T] [A/T] Harness Connector
Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Components and components location
Component Location 1. Heater unit assembly Compoents 1. Mode control actuator 2. Heater core case 3. Center duct seal 4. PTC heater 5. Heater core assembly 6. Heater case [LH] 7.
Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Instrument Cluster
- Child-Protector Rear Door Locks
- Normal Maintenance Schedule
- New on site
- Most important about car
