Hyundai Venue (QX): Engine Control System / Variable Intake Solenoid (VIS) Valve. Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Description and operation

Description
Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens or closes this valve according to engine condition (Refer to below table).

Hyundai Venue. Variable Intake Solenoid (VIS) Valve. Description and operation

Engine condition
VIS Valve
Operation
Medium speed
 Closed
 Increasing engine performance in low engine speed by reducing intake interference among cylinders
Low / High speed
 Open
 Minimizing intake resistance by shortening intake manifold length and increasing area of air entrance

Hyundai Venue. Variable Intake Solenoid (VIS) Valve. Description and operation

    Inspection 1. Turn ignition switch OFF. 2. Disconnect OCV connector. 3. Measure resistance between OCV terminals 1 and 2.

    Circuit Diagram [M/T] [A/T] Harness Connector

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures

    Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright В© 2026 www.hvenueqx.com - 0.0127