Hyundai Venue (QX): Starter / Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Electrical System / Starting System / Starter / Description and operation

Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.The contacts close and the starter motor cranks.
In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

Hyundai Venue. Description and operation

1. Switch assembly
2. Brush assembly
3. Armature
4. Over runing clutch

    Specification Item Specification Rated voltage 12V, 0.9 kW The number of pinion teeth 10 Performance [No-load, 11.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: PTC Heater. Repair procedures

    Inspection Operating Logic Test (Manual only) Inspect the PTC operation by confirmation logic as follows; 1. Entering (1) Set the Floor mode and maximum heating position. (2) Turn off the blower switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Repair procedures

    Variant Coding    When you need variant coding: – Replace Front View Camera with a new one ※ EOL Variant Coding and calibration required for new replacement Front View Camera Variant Coding

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0244