Hyundai Venue (QX): Tire Pressure Monitoring System / Description and operation

Hyundai Venue (QX) (2020-2026) Service Manual / Suspension System / Tire Pressure Monitoring System / Description and operation

Description
The Tire Pressure Monitoring System (TPMS) monitors the pressure and temperature inside the tire in order to warn the driver of changes in pressure which may influence the operation of the vehicle. The TPMS control module analyzes wireless information fro
In other words, the system detects the pneumatic pressure of the tires and warns the driver of if the pneumatic pressure drops below the standard level.
Low-pressure Warning Lamp on the Dashboard
Dashboard tire low-pressure warning light

Hyundai Venue. Description and operation

Lamp ON/OFF Conditions when the Tire Pressure Decreases or Air is Leaking from the Tire
1.
Lamp ON
•
The lamp turns ON when the tire pressure decreases below the standard level.
2.
Lamp OFF
•
Low pneumatic pressure: The warning lamp turns OFF when the tire pressure exceeds the pressure required to turn off the lamp.
TPMS Fault Warning Lamp
1.
Warning Conditions and Display
•
When the system detects a defect in the external operating environment (low battery voltage, abnormal vehicle speed, etc), the warning lamp blinks for about 1 minute and then turns ON.
2.
Lamp OFF
•
The warning lamp turns OFF when the DTC is resolved. The DTC is automatically resolved when the system does not receive any fault signals for 30 or more ignition cycles after it changes to the previous fault code.
Hyundai Venue. Description and operation   
•
If this phenomenon occurs while driving, you should check the cause of the fault even after the DTC is resolved.
(Turn the ignition switch from OFF to ON. Then, check the lamp status.)
•
The warning lamp turns off once the DTC is resolved. The warning lamp stays on until you complete the check necessary to resolve the DTC.
•
If the DTC is resolved, the warning lamp turns OFF during the same ignition cycle.
Hyundai Venue. Description and operation   
If the vehicle starts within 19 minutes after the replacement of the wheel of the stopped vehicle, the TPMS Malfunction Indicator on the instrument cluster illuminates.
–
The above symptom is due to communication failure between the IBU and the replaced TPMS ID.
–
This communication failure indicator turns off in 19 minutes after the vehicle stops through the IBU’s automatic learning process of TPMS ID.
(When driving the vehicle after stopping for over 19 minutes, the indicator turns off automatically.)
System Defect
1.
General Operation
•
The system detects many input elements to identify potential defects.
•
The priority of a defect depends on its cause.
•
Certain defects are not diagnosed as DTCs.
The following are major defects:
•
In order to diagnose more symptoms of the fault when the ignition line malfunctions, you must check the warning lamp when you turn the ignition on.
•
Check whether the warning lamp turns on and then off.

    Components 1. Integrated Body Control Unit (IBU) 2. TPMS sensor (FL) 3. TPMS sensor (RL) 4. TPMS sensor (RR) 5.

    TPMS Inspection method Inspection    • Find the inspection number by referring to the table above.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Hyundai Venue (QX) (2020-2026) Service Manual: Mode Control Actuator. Components and components location

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0207