Hyundai Venue (QX): Driveshaft Assembly / Dynamic Damper. Components and components location
| Components |
| 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper 6. Shaft 7. TJ boot band 8. TJ boot |
9. Spider assembly 10. Snap ring 11. TJ housing 12. Clip |
Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2.
Removal 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - "Front Driveshaft") 2.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Repair procedures
Removal Precautions for using the plastic pulley • Be careful not to place the pulley to downwards of the floor or table.
Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Rear Seat Assembly. Repair procedures
- Operating Door Locks from Outside the Vehicle
- Remote start
- New on site
- Most important about car
