Hyundai Venue (QX): Front Bumper / Front Bumper Cover. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover. Repair procedures

Replacement
Hyundai Venue. Front Bumper Cover. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Loosen the front bumper upper mounting bolts.

Hyundai Venue. Front Bumper Cover. Repair procedures
2.
Loosen the front bumper lower mounting clips.

Hyundai Venue. Front Bumper Cover. Repair procedures
3.
Loosen the mounting clips and screws on the side of front bumper (A), detach the side part of rear bumper.
Hyundai Venue. Front Bumper Cover. Repair procedures   
•
When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

Hyundai Venue. Front Bumper Cover. Repair procedures
4.
Press the lock pin and separate the front bumper cover connector (A).

Hyundai Venue. Front Bumper Cover. Repair procedures
5.
Remove the front bumper cover (A).

Hyundai Venue. Front Bumper Cover. Repair procedures
6.
To install, reverse removal procedure.
Hyundai Venue. Front Bumper Cover. Repair procedures   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front bumper cover

    Component Location 1. Radiator grill

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Intake Actuator. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.

    Hyundai Venue (QX) (2020-2026) Service Manual: Warning Indicator. Repair procedures

    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front door trim") 3. Disconnect the power door mirror connector from the harness 4.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0172