Hyundai Venue (QX): Front Door / Front Door Latch. Repair procedures

Replacement
Hyundai Venue. Front Door Latch. Repair procedures   
•
When removing with a flat-tip screwdriver or remover,wrap protective tape around the tools to preventdamage to components.
•
Take care not to scratch the body surface.
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
Separate the front door outside handle connector (A) and remove the wiring harness (B).

Hyundai Venue. Front Door Latch. Repair procedures

3.
Remove the front door inside handle case (A) and remove the rubber packing (B).

Hyundai Venue. Front Door Latch. Repair procedures

4.
Remove the front door latch (A) by gently lifting the locking pin (B).

Hyundai Venue. Front Door Latch. Repair procedures

5.
Open the cover to remove the rod (A) and remove the front door outside handle base (B).

Hyundai Venue. Front Door Latch. Repair procedures

6.
To install, reverse removal procedure.
Hyundai Venue. Front Door Latch. Repair procedures   
•
Make sure the connector is connected properly.
•
Make sure the door locks / unlocks and opens / closes properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front door latch

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Description and operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.

    Hyundai Venue (QX) (2020-2026) Service Manual: Heater Unit. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station. 3. When the engine is cool, drain the engine coolant from the radiator.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.014