Hyundai Venue (QX): Fuel Delivery System / Fuel Line. Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF, and then remove battery (-) cable.
|
| 2. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel
Line")
|
| 3. |
Disconnect the fuel feed tube (A) after remove the nuts (B).
|
| 4. |
Disconnect the vapor tube quick-connector (C) which is connected from
the PCSV.
|
| 5. |
Lift the vehicle.
|
| 6. |
Remove the fuel tank.
(Refer to Fuel Delivery System - "Fuel Tank")
|
| 7. |
Remove the vapor tube and fuel feed tube line fixing clips (A) by using
a common driver.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Open the fuel filler door and unfasten the filler-neck assembly mounting botl (A).
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Heater Core. Repair procedures
Replacement 1. Remove the heater unit assembly. (Refer to Heater - "Heater Unit") 2. Loosen the mounting screws and remove the heater core cover (A). 3.
Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Maintenance
- Electronic Stability Control (ESC)
- Engine Mechanical System
- New on site
- Most important about car
