| General Information |
| 1. |
DC/DC converter : DC/DC converter in power supply unit includes up/down
transformer converter, and provides ignition voltage for all firing
circuits, implemented as ASICs and the internal operation voltage of
the SRSCM itself. if the internal operation voltage is below critical
value setting, it will perform resetting.
|
| 2. |
Back up power supply : SRSCM has separate back up power supply, that
will supply deployment energy instantly in low voltage condition or
upon power failure by front crash.
|
| 3. |
Self diagnosis : SRSCM will constantly monitor current SRS operation
status and detect system failure while vehicle power supply is on, system
failure may be checked with trouble codes using GDS.
|
| 4. |
Airbag warning lamp on : Upon detecting error, the module will transmit
signal to SRSCM indicator lamp located at cluster. MIL lamp will indicat
to the driver that there is an SRS error. Upon ignition key on, SRS
lamp will turn on for about six seconds.
|
| 5. |
Trouble code registration: Upon error occurrence in system, SRSCM will
store DTC corresponding to the error. DTC can be cleared only by GDS.
However, if an internal fault code is active or if a crash is recorded
the fault clearing cannot be performed.
|
| 6. |
Self diagnostic connector : Data stored in SRSCM memory will be output
to GDS or other external output devices through a connector located
below driver side crash pad.
|
| 7. |
Once airbag is deployed, SRSCM should not be used again but replaced.
|
| 8. |
SRSCM will determine whether passenger fasten the seat belt by the signal
from built-in switch in seat belt buckle, and deploy front seat airbag
at each set crash speed.
|
| 9. |
Side airbag deployment will be determined by SRSCM that will detect
satellite sensor impact signal upon side crash, irrespective to seat
belt condition.
|
Specification Item Resistance (Ω) Driver Airbag (DAB) 2.2 - 6.0 Passenger Airbag (PAB) 1.
Special Service Tools Tool Name / Number Illustration Description LKA Compensator (09890-3V100) Used for compensating front view camera unit BCW Sensor Correction Tool Set (09958-3T500) Used to correct the blin
Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.