Hyundai Venue (QX): Hood / Hood Assembly. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Hood / Hood Assembly. Repair procedures

Replacement
Hyundai Venue. Hood Assembly. Repair procedures   
•
Be careful not to damage the hood and body.
Hyundai Venue. Hood Assembly. Repair procedures   
•
Removing or installing the hood requires an assistant.
•
When removing the clips, use a clip remover.
1.
Loosen the hood hinge mounting bolts (A) and remove the hood assembly (B).
Tightening torque :
21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)

Hyundai Venue. Hood Assembly. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Venue. Hood Assembly. Repair procedures   
•
Make sure the hood locks / unlocks and opens / closes properly.
•
Adjust the hood alignment.

    Component Location 1. Hood assembly

    Replacement 1. Using a clip remover, remove the clips and then the hood insulator pad (A).    • Be careful not to scratch the hood panel.

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Blower Unit. Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery / recycling / charging station. 3. When the engine is cool, drain the engine coolant from the radiator.

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.014