Hyundai Venue (QX): Hood / Hood Assembly. Components and components location
| Component Location |
| 1. Hood assembly |
Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.
Replacement • Be careful not to damage the hood and body.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Blower Resistor (Manual). Repair procedures
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.
Hyundai Venue (QX) (2020-2026) Service Manual: Heater & A/C Control Unit (Manual). Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the console upper front garnish. (Refer to Floor Console - "Floor Console Assembly") 3.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Rear Seat Assembly. Repair procedures
- Operating Door Locks from Outside the Vehicle
- Remote start
- New on site
- Most important about car
