Hyundai Venue (QX): Hydraulic System / Mechanical Oil Pump. Components and components location
| Components |
| 1. Housing - Oil pump 2. Cover - Oil pump 3. Gear - Oil pump drive 4. Gear - Oil pump driven 5. Shaft - Reaction 6. Oil - Seal |
7. Sleeve 8. Bearing - Housing 9. Cap - Sealing 10. Needle roller bearing 11. Bolt 12. Snap ring - Housing |
Description • The oil pump is built-in as a single unit with the 26 Brake chamber. • Rotation of the pump builds the hydraulic pressure needed for the lubrication of the various parts of the transaxle and operation of the clutch and brakes.
Removal 1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Description and operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation
Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Rear Seat Assembly. Repair procedures
- Automatic Transaxle Fluid (ATF). Repair procedures
- Engine Coolant
- New on site
- Most important about car
