Hyundai Venue (QX): Speedometer & Tachometer / Odometer & Range
Odometer
The odometer indicates the total distance that the vehicle has been driven and should be used to determine when periodic maintenance should be performed.
Range
- The range is the estimated distance the vehicle can be driven with the remaining fuel.
- If the estimated distance is below 1 mi. (1 km), the trip computer will display "----" as range.
Information
- If the vehicle is not on level ground or the battery power has been interrupted, the range function may not operate correctly.
- The range may differ from the actual driving distance as it is only an estimate of the available driving range for the vehicle and driving conditions.
- The trip computer may not register additional fuel if less than 1.6 gallon (6 liters) of fuel are added to the vehicle.
- The range may vary significantly based on driving conditions, driving habits, and condition of the vehicle.
This gauge indicates the current outside air temperature by 1°F (1°C). -- Temperature range: -40°F ~ 140°F (40°C ~ 60°C) Note that the temperature indicated on the LCD display may not change as quickly as the outside temperature (there may be a slight delay before the temperature changes.
Manual transmission shift indicator (if equipped) This indicator informs which gear is desired while driving to save fuel. Shifting up : â–²2, â–²3, â–²4, â–²5, â–²6 Shifting down : â–¼1, â–¼2, â–¼3, â–¼4, â–¼5 For example : Indicates that shifting up to the 3rd gear is desired (currently, the shift lever is in the 2nd or 1st gear).
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Description and operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Hyundai Venue (QX) (2020-2026) Service Manual: Mode Control Actuator. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Rear Seat Assembly. Repair procedures
- Front Suspension System
- Child-Protector Rear Door Locks
- New on site
- Most important about car
