Hyundai Venue (QX): Blower / Power Mosfet. Description and operation
| Description |
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.
Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced.
Other information:
Hyundai Venue (QX) (2020-2026) Service Manual: Compressor. Components and components location
Components Location 1. Compressor Components 1. Clutch bolt 2. Disc & Hub assembly 3. Clutch hub spacer 4. Snap ring 5. Pulley 6. Clutch magnetic coil 7.
Hyundai Venue (QX) (2020-2026) Service Manual: Receiver-Drier. Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.
Categories
- Manuals Home
- Hyundai Venue Owners Manual
- Hyundai Venue Service Manual
- Maintenance
- Engine Mechanical System
- Engine Electrical System
- New on site
- Most important about car
