Hyundai Venue (QX): Rear Seat Belt / Rear Seat Belt Buckle. Repair procedures

Replacement
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Cushion Assembly")
2.
Press the lock pin and separate the connector (A).
3.
Loosen the mounting bolt and remove the rear seat belt buckle (B).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.8 - 39.8 lb-ft)
[RH]

Hyundai Venue. Rear Seat Belt Buckle. Repair procedures

[LH]

Hyundai Venue. Rear Seat Belt Buckle. Repair procedures

4.
To install, reverse removal procedure.
Hyundai Venue. Rear Seat Belt Buckle. Repair procedures   
•
The buckle and tongue of different types are impossible to be latched, so check that the buckle & tongue have the same types.
•
Distinguish the rear side seat buckle from the center seat buckle before latching.
•
If foreign materials are stuck in the inside button of buckle, it may cause interference during the latching process, leading to a functional problem (for example- beverages (viscous drinks), toothpicks, sand, plastic, vinyl, metal pieces, etc.).
•
After latching the buckle and tongue, check the fastening force using a Push-Pull Gauge (fastening force: 3kgf or less)

    Component Location 1. Rear seat belt buckle [RH] 2. Rear seat belt buckle [LH] 3. Rear center seat belt buckle

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Temperature Control Actuator. Description and operation

    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

    Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0169