Hyundai Venue (QX): Interior Trim / Rear Transverse Trim. Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Transverse Trim. Repair procedures

Replacement
Hyundai Venue. Rear Transverse Trim. Repair procedures   
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the luggage covering bord (A).

Hyundai Venue. Rear Transverse Trim. Repair procedures
2.
Loosen the mounting clips and remove the rear transverse trim (A).

Hyundai Venue. Rear Transverse Trim. Repair procedures
3.
To install, reverse removal procedure.
Hyundai Venue. Rear Transverse Trim. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Rear transverse trim

    Component Location 1. Luggage side trim

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: Evaporator Temperature Sensor. Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.

    Hyundai Venue (QX) (2020-2026) Service Manual: Components and components location

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0149