| Inspection |
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir
tank with water.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Connect positive (+) and negative (-) battery cables to terminals 3
and 1 respectively to see that the washer motor runs and water is pumped.
|
| 4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
|
Inspection [Wiper Switch / Washer Switch] 1. Check for continuity between the terminals in each switch position as shown below.
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord