Hyundai Venue (QX): Manifold Absolute Pressure Sensor (MAPS) / Repair procedures

Hyundai Venue (QX) (2020-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) / Repair procedures

Inspection
1.
Connect a diagnostic tool on Data Link Connector (DLC).
2.
Check MAPS output voltage at idle and IG ON.
Condition
Output Voltage (V)
IG ON
 3.9 - 4.1
Idle
 0.8 - 1.6

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Disconnect the manifold absolute pressure sensor connector (A).
3.
Remove the mounting bolt (B), and then remove the sensor from the intake manifold.
Manifold absolute pressure sensor installation bolt :
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

Hyundai Venue. Repair procedures
Installation
Hyundai Venue. Repair procedures   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Hyundai Venue. Repair procedures   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Install in the reverse order of removal.

    Circuit Diagram [M/T] [A/T] Harness Connector

    Other information:

    Hyundai Venue (QX) (2020-2026) Service Manual: In-car Sensor. Description and operation

    Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and accord

    Hyundai Venue (QX) (2020-2026) Service Manual: Description and operation

    Description and Operation Blcok Diagram    • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.

    Categories

     
    Copyright © 2026 www.hvenueqx.com - 0.0104